The article "Mathematical and physical simulation of diagnostics problem on the test rotor stand" is published in the "Publications" section.

Dynamics SPC has succesfully taken a certification auditory inspection in order to prove compliance to ISO 9001:2015 international standard. The inspection was provided by a world-famous certification organization TÜV Rheinland Group.

As the result of the inspection,  Dynamics SPC was issued an internationaly valid certificate:

;

Dynamics SPC has succesfully taken a certification auditory inspection in order to prove compliance to ISO 9001:2015 international standard. The inspection was provided by a world-famous certification organization TÜV Rheinland Group.

As the result of the inspection,  Dynamics SPC was issued an internationaly valid certificate:

;

The article "Development of methodological support for turbine unit shaft defect and stress monitoring systems at thermal power stations and atomic power stations with application of shaft displacement sensors" is published in the "Publications" section.

The article "Formation of diagnostic signs vector on the basis of a characteristic function of a vibro-acoustic signal" is published in the "Publications" section.

The article "Assessment of failure probability and operation risks of process plants according to data of condition monitoring systems" is published in the "Publications" section.

The article "Calculation and Interpolation of the Characteristics of the Hydrodynamic Journal Bearings in the Domain of Possible Movements of the Rotor Journals" is published in the "Publications" section.

The article "Shaft sensor based on modeling diagnostic signs of power unit defects" is published in the "Publications" section.

The article "Intelligent machinery condition monitoring based on adaptive measurements" is published in the "Publications" section.

The COMPACS RPP System for Rolling Bearing Diagnostics  implemented at Krasnodar Refinery

In June 2019 in the city of Krasnodar DYNAMICS SPC's specialists implemented the COMPACS RPP System for Rolling Bearing Diagnostics to the local refinery. The system comprises of Drive 1602 providing an automatic diagnostics of bearings with a bore diameter of 40 -120 mm.

The COMPACS RPP System is used for an acceptance testing of bearings by dividing them into three categories based  on their quality, thus, allowing only bearings with maximum potential lifespan to be comissioned for operation. During the refinery personnel's training course, about 50% of bearings was rejected by the system due to their poor quality.