In "Publications" section the article "Estimating the efficiency of repairs to oil refineries" (A.V. Kostyukov, 2008) has been placed.

In "Publications" section the article "On-line monitoring of motor driven rolling stock" (V.N. Kostyukov, A.V. Kostyukov, S. Sizov, V.P. Aristov, 2008) has been placed.

In "Publications" section the article "Problems and solutions for safe operation of reciprocating compressors" (V.N. Kostyukov, A.P. Naumenko, 2008) has been placed.

In "Publications" section the article "Safe resource-saving operation of motor driven rolling stock (MDRS) based on real-time condition monitoring" (V.N. Kostyukov, A.V. Kostyukov, S.V. Sizov, V.P. Aristov, 2008) has been placed.

In "Publications" section the article "Condition monitoring system COMPACS^® for wheel-rolling mill" (V.N. Kostyukov, S.N. Boychenko, Al.V. Kostyukov, A.A. Sinitsyn, A.M. Volkov, O.V. Kuznetsov, 2008) has been placed.

In "Publications" section the article "Comprehensive Condition Monitoring of hazardous production facilities" (V.N. Kostyukov, A.P. Naumenko S.N. Boychenko, Al.V. Kostyukov, E.V. Tarasov, 2008) has been placed.

DYNAMICS SPC got explosion apparatus examination certificates

Recertification of products of DYNAMICS SPC in compliance with the requirements for explosion apparatus was held in July 2011.

• System of automatic vibration analysis and condition monitoring COMPACS^®, which allows automatically receive and use objective information of the units condition for maintenance and repair of equipment, as well as identify and eliminate the fundamental causes of equipment failure (LiFCF™).
• Vibration calibrator 8001 is designed for calibrating vibration sensors in hazardous areas.

Each product is certificated.

In "Publications" section the report "Diagnostic system of electrical circuit of motor driven rolling stock" (Al.V. Kostyukov, D.V. Kazarin, 2008) has been placed.

DYNAMICS SPC took part in VIII International Conference "Condition Monitoring and Machinery Failure Prevention Technologies" ("CM/MFPT")

Conference "Condition Monitoring and Machinery Failure Prevention Technologies - 2011", organized by the British Institute of NDT (The British Institute of non-destructive testing), was held in June, 20-22 in Cardiff (Wales), in The St. David's Hotel.

The Director General of DYNAMICS SPC Vladimir N. Kostyukov, winner of the Russian Federation Government Prize, Ph.D., Professor, presented his report "Real-time condition monitoring of machinery by the recurrent selection of the noise and periodic components of vibration" in section "Real-time condition monitoring of the equipment".

DYNAMICS SPC took part in the IX International Exhibition of international high-tech equipment and weapons "VTTV-2011"

The exhibition was held in July 6-9, 2011 in Omsk Expocentre.

DYNAMICS SPC presented the following product samples:

• Computer Systems of Condition Monitoring for Equipment Control and Accidents Prevention COMPACS^®. The diagnostic station is of industrial version. As a diagnostic controller, industrial fanless fault-tolerant computer designed by DYNAMICS SPC is used, which performs system control functions, measurement, archiving, analysis, visualization of measured parameters and expert system reports.
• Calibrator 8003 intended for checking and calibration systems and devices that measure vibration, voltage and double-current intensity, as well as temperature.
• Vibration calibrator 8001 intended for calibrating of vibration-measuring apparatus and vibration-measuring transducers in laboratory and production conditions, and where the use of state vibration-calibration apparatus is impossible or impractical.

During the exhibition a roundtable discussion on "Current questions of development of "Siberian Engineering" was held which was attended by Director General of DYNAMICS SPC Vladimir N. Kostyukov and First Deputy Director General of DYNAMICS SPC Andrey V. Kostyukov.